rboucher
Member
|
Sub Box design question
I am building subwoofer a box, and i got the box specs from the driver mfr, (Vb, VTotal, Fb, and port sizes, among others) but i need to translate that into blueprints.
How would i go about this? Is there software available or a formula, or do i get a pencil and scratch paper and just start drawing until i get it right?
Also, they said that port noise is a consideration with the recommended ports, that i could try flared, but i would have to know how to tune them.
Is that difficult?
thanks for any help to make this easier.
Bobby
Report this post to a moderator
|
03-23-2006 02:12 PM
