punch bd1000 @ 2-15" cvr's a 129db.. can i get better out of them?

punch bd1000 @ 2-15" cvr's a 129db.. can i get better out of them? I am wondering if i can get any more out of them what can i do i dont have a cap or anything just the bass knob with the gain and hertz on it, all i have is the 25$ meter from walmart justwondering what i can do with out getting any more speakers or box right now... it is a sealed box... and if i was to upgrade speakers what should i upgrade too.. dont want to spend thousands maybe from about 300-600 or so but use my original box special built to my hardbdy behind the seats... theyare 2 ohm speakers is that a good reading for that?? just not starting to get into it and this is the first set up i owned...

Report this post to a moderator

 

yeah get a kicker amp and a cap and a ported box would get u more spl

Report this post to a moderator

 

add some sound deadening material like dynamat extreme in the trunk area and the rear deck

Report this post to a moderator

 

If your getting that reading off that Walmart meter, you are probably alot louder. Go to a shop that has a termlab meter and get measured. As far as getting louder. Go with a ported box about 4-4.5 cuft. per sub tuned to about 35hz. Hope this helps you.

Report this post to a moderator

 here is help

ok are the subs single or dual voice coils..if they are single two ohm and u have them wired in series u only have four ohm load on ur amp//so it making half the power it could..it needs two ohm load..if ur subs are svc two ohm and u parallel them u have one ohm load..to low for ur amp...if they are dvc two ohm if u series one sub u get four ohm then series the other u get four ohm then parallel them to the amp u get the proper two ohm load u need to put out the rated power of ur amp..

Report this post to a moderator