Really need help with my amp.. im stumped

alright, so im at the edge of my limit with my stereo. I had a 1100 watt crunch amp powering two 12 inch polkaudios. one day it randomly quit working in the middle of driving. I checked all the wires, re grounded the wires, and checked everything. The amp lights up and is not in protect mode, but apparently the channels fried. I grabbed my extra boss amp and hooked it up, and it wouldnt turn on. Figuring it might be bad, I grabbed my bazooka sub and amp(which was working last time i turned my other car off), and it wouldnt turn on either, yet my crunch amp will. I feel like it could be the remote wire, but the crunch amp will power on just not these. All wires are good, all fuses are good. I dont know what to do.. please help

Report this post to a moderator

 

If the wires were all good, there wouldn't of been a issue to begin with.
If the wires were all good, then a amp that works, will work.
Think about it!

Report this post to a moderator

 

well the amps i have are both fairly new and dual amps mine have rca inuts on them as i suspect yours do try changing them on ur crunch amp as for the other two amps i have no idea why they wouldnt work maybe replace all of your wiring make sure your ground is clean and i mean if thats not the problem you have used $50 and 2-3 hours of your time and i mean no harm was done it cant hurt but as far as your crunch amp id go ahead and try redoing the rca cables or whatever you have run for sound from the radio to the amp

Report this post to a moderator